All items that fit a Toyota Yaris 2018

Will fit in a ?

No, it won't fit.

It will not fit in this setup: LACK Coffee table, white, 46 1/2x30 3/4″ is too large for a Toyota Yaris 2018 with seats up.

Toyota Yaris 2018

Fit Details

With seats up, This package will not fit in this setup. The blocker is opening width, and you're short by 9⅞″ even with diagonal loading. We're about 95% confident in this estimate.

LACK Coffee table, white, 46 1/2x30 3/4″

LACK Coffee table, white, 46 1/2x30 3/4″

Box: 55″ × 31¼″ × 2¾″ · 38 lb 9 oz

Based on IKEA US (United States).

Package dimensions last checked and updated on Oct 21, 2026

  • Package #1

    55″ × 31¼″ × 2¾″

    Status:9⅞″ short

    Limiting factor:Opening width

    Best orientation:Diagonal

Vehicle limits

Trunk limits for Toyota Yaris 2018

Opening width / height above sill

34⅝″ / 27½″

Cargo width / height

39¾″ / 34¼″

Cargo length seats up / down

26¾″ / 52⅜″

Loading sill height

26¾″

Toyota Yaris 2018

Measurements last checked and updated on Oct 21, 2026

Helpful tips

Use these loading tips to improve your chances of fitting LACK Coffee table, white, 46 1/2x30 3/4″ in Toyota Yaris 2018.

  • Optimize opening width

    Keep the narrow edge leading while entering the opening.

  • Load diagonally first

    Load diagonally first, then straighten once inside.

  • Try fitting alternatives

    Check the Similar items that fit section for safer alternatives.

About the Toyota Yaris 2018 boot

Everything you load into the Toyota Yaris 2018 boot has to pass an opening 34⅝″ wide, with 27½″ of clear height above a 26¾″ sill. Past it, the space opens up: the floor is no less than 39¾″ wide, it lies 6¾″ below the sill, and the boot rises 34¼″ above that floor. The floor is only 26¾″ long with the rear seats up, and folding them adds 25⅝″ to reach 52⅜″. Short, chunky boxes suit it, and a few boxes longer than 26¾″ fit with the seats up, turned on their side. So measure every box against those two opening figures first.

About the LACK Coffee table, white, 46 1/2x30 3/4″ package

One broad, thin box holds the LACK coffee table: 55″ × 31¼″ × 2¾″, at 38 lb 9 oz. At 31¼″ across, it is hard to carry alone and hard to see past. Lying flat and straight, it needs a floor 55″ long and 31¼″ wide. On its side and at an angle, it can fit in a shorter boot. A thin box like this takes its damage at the corners, mostly when you set it down. Carry it with a second person, one on each long side, and lower it slowly, never corner first.

Frequently asked questions

Find quick answers about fit for LACK Coffee table, white, 46 1/2x30 3/4″ in Toyota Yaris 2018, including seats up vs seats down, limiting factor, best orientation, and package-by-package margins.

Will LACK Coffee table, white, 46 1/2x30 3/4″ fit in Toyota Yaris 2018?

No. With seats up, it is short by 9⅞″ at Opening width, even with diagonal loading.

What is the tightest part?

The limiting factor is Opening width, with -9⅞″ margin in seats up.

Why does it not fit?

The blocker is Opening width: with seats up, the box is 9⅞″ bigger than the space there.

Can I load it diagonally?

Yes, diagonal is the best orientation for this check, with -9⅞″ around the limiting point.

Which loading orientation works best?

Diagonal is the best orientation for this result in seats up.

Does it fit with seats up or seats down?

Seats up: No (-9⅞″). Seats down: No (-2⅝″). Default selection follows YES > MAYBE > NO.

What do YES, MAYBE and NO mean here?

YES means there is at least 2⅜″ to spare at the tightest point, in the best way the box can go in. MAYBE means it fits on paper, but with less than 2⅜″ to spare, so trim, the parcel shelf or the loading angle can decide it. NO means the box is bigger than the space at its tightest point, whichever way it goes in. Every margin on this page is that real gap: the car's measurement minus the box's.

What should I do instead?

Use the Helpful tips & alternatives section to choose a smaller item, different orientation, or split-load plan.

Is the trunk opening the issue?

Yes. The tightest constraint is at the opening (Opening width) with -9⅞″ margin.

How tight is this fit?

This result is in the clear no-fit band (-9⅞″ at Opening width).