NORDEN Gateleg table, birch, 26/89/152x80 cm
+7.2 cm margin
WillNORDLI Bed frame with storage, white, 160x200 cmfit in aToyota Yaris 2018?
No, it won't fit.
It will not fit in this setup: NORDLI Bed frame with storage, white, 160x200 cm is too large for a Toyota Yaris 2018 with seats up.
Fit Details
With seats up, This package will not fit in this setup. The blocker is opening width, and you're short by 84.3 cm even with diagonal loading. We're about 95% confident in this estimate.
NORDLI Bed frame with storage, white, 160x200 cm
Box: 207 × 39 × 10 cm · 26.75 kg
Based on IKEA UK (United Kingdom).
Package dimensions last checked and updated on Jun 17, 2026
Package
Status
Limiting factor
Best orientation
Package #1
207 × 39 × 10 cm
Status:84.3 cm short
Limited by
Limiting factor:Opening width
Best orientation:Diagonal
Vehicle limits
Opening width / height
88 cm / 87 cm
Cargo width / height
101 cm / 104 cm
Cargo length seats up / down
68 cm / 133 cm
Loading sill height
68 cm
Toyota Yaris 2018
Measurements last checked and updated on Jul 15, 2026
Helpful tips
Use these loading tips to improve your chances of fitting NORDLI Bed frame with storage, white, 160x200 cm in Toyota Yaris 2018.
Optimize opening width
Keep the narrow edge leading while entering the opening.
Load diagonally first
Load diagonally first, then straighten once inside.
Try fitting alternatives
Check the Similar items that fit section for safer alternatives.
Alternatives that fit in Toyota Yaris 2018
Ranked by fit margin and package-dimension similarity. This improves as we index more items.
About the Toyota Yaris 2018 boot
The Toyota Yaris gives you a compact hatchback boot. The opening is 88 cm wide and 87 cm tall, and the floor runs 68 cm deep with the seats up, enough for a weekly shop, a pushchair, or a few small boxes. Fold the rear bench and the floor extends to 133 cm, a gain of 65 cm, which nearly doubles what you can carry. Long loads like bed frames or wardrobe panels still overhang and will not go. You lift over a 68 cm sill then drop 17 cm into the well, so slide heavy boxes in rather than lower them by hand.
About the NORDLI Bed frame with storage, white, 160x200 cm package
The NORDLI bed frame with storage comes as five flat packs and totals 123.5 kg: a serious load. The largest pack is 207 cm long, 39 cm wide, 10 cm thick, and that long box drives every fit decision. Hatchbacks need the rear bench folded and the diagonal route across the cabin. Estates, large SUVs, and vans take it comfortably. Load the long pack first along the floor, then stack the four shorter cartons on top in size order. Bring a friend and a pair of gloves.
On pickup day
No fit here. The NORDLI bed frame packs into a 207 cm box, and the Toyota Yaris opening is 88 cm wide, leaving you 84.3 cm short with the seats upright. Drop the rear bench and you gain 32.6 cm, but you remain 51.7 cm short, because the boot floor only reaches 133 cm folded. This is a long, flat panel built for a bigger car. Bring an estate or arrange delivery. Before you drive over, measure the actual box, since IKEA pack sizes shift between updates.
Frequently asked questions
Find quick answers about fit for NORDLI Bed frame with storage, white, 160x200 cm in Toyota Yaris 2018, including seats up vs seats down, limiting factor, best orientation, and package-by-package margins.
Will NORDLI Bed frame with storage, white, 160x200 cm fit in Toyota Yaris 2018?
No. With seats up, it is short by 84.3 cm at Opening width, even with diagonal loading.
What is the tightest part?
The limiting factor is Opening width, with -84.3 cm margin in seats up.
What should I do instead?
Use the Helpful tips & alternatives section to choose a smaller item, different orientation, or split-load plan.
Is the trunk opening the issue?
Yes. The tightest constraint is at the opening (Opening width) with -84.3 cm margin.
How tight is this fit?
This result is in the clear no-fit band (-84.3 cm at Opening width).
Does it fit with seats up or seats down?
Seats up: No (-84.3 cm). Seats down: No (-51.7 cm). Default selection follows YES > MAYBE > NO.
Why does it not fit?
The blocker is Opening width. The worst margin is -84.3 cm in seats up, so clearance is below the required buffer.
Can I load it diagonally?
Yes, diagonal is the best orientation for this check, with -84.3 cm around the limiting point.
Which loading orientation works best?
Diagonal is the best orientation for this result in seats up.
How confident is this result?
Confidence is 95 out of 100 based on available dimensions and margin tightness.