Willfit in a?

No, it won't fit.

For BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm in a Renault Captur 2024 with seats up: 1 of 3 packages fit, 1 package is a borderline fit, and 1 package does not fit.

Renault Captur 2024

Fit Details

With seats up, Not a full fit. 1 of 3 packages fit, 1 is borderline, and 1 does not fit. Worst case is Package #1 (206 × 59 × 7 cm), short by 75.6 cm at opening width. Packages that do not fit will need a larger vehicle or delivery. We're about 95% confident in this estimate.

BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm

BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm

Box: 206 × 59 × 7 cm · 39.7 kg

Based on IKEA UK (United Kingdom).

Package dimensions last checked and updated on Mar 25, 2026

  • Package #1

    206 × 59 × 7 cm

    Status:75.6 cm short

    Limiting factor:Opening width

    Best orientation:Diagonal

  • Package #2

    96 × 58 × 9 cm

    Status:+2.3 cm tight

    Limiting factor:Opening width

    Best orientation:Diagonal

  • Package #3

    93 × 56 × 9 cm

    Status:+4.7 cm margin

    Limiting factor:Opening width

    Best orientation:Diagonal

Vehicle limits

Trunk limits for Renault Captur 2024

Opening width / height

94 cm / 82 cm

Cargo width / height

102 cm / 102 cm

Cargo length seats up / down

67 cm / 144 cm

Loading sill height

78 cm

Renault Captur 2024

Measurements last checked and updated on Jul 08, 2026

Helpful tips

Use these loading tips to improve your chances of fitting BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm in Renault Captur 2024.

  • Optimize opening width

    Keep the narrow edge leading while entering the opening.

  • Load diagonally first

    Load diagonally first, then straighten once inside.

  • Plan package order

    Load each package one at a time. Individual package fit does not guarantee all packages will fit stacked together.

  • Try fitting alternatives

    Check the Similar items that fit section for safer alternatives.

About the Renault Captur 2024 boot

The Captur gives you a compact, upright boot rather than a long one. Behind the rear seats the floor runs about 67 cm, so tall and square boxes load well but long flat-packs sit at an angle. The opening is 94 cm wide and 82 cm tall, with a 20 cm drop from the sill down to the floor, so you lift over the lip and set the box down inside. Fold the rear bench and the floor grows to 144 cm, a gain of 77 cm that decides most borderline loads. For long boxes, feed them in low and straight along the 102 cm width and keep weight off the parcel shelf.

About the BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm package

The BRIMNES day-bed ships in three flat packs, and the long one is the problem: 206 cm long, 59 cm wide, only 7 cm thick. Stacked weight comes in at 83.8 kg, so two pairs of hands beat one. The 2 m length rules out small hatchbacks even with the bench folded. Estates, large SUVs, and vans take it without drama. For anything in between, plan the diagonal route through the cabin and check the path past the parcel shelf clips. Load the long pack first, then the two shorter boxes on top.

On pickup day

This one is a no in the Renault Captur, and it is not close. The BRIMNES day-bed at 206 cm long overshoots the boot by 75.6 cm with the seats up, measured diagonally against the 94 cm opening. Fold the rear bench and you claw back 38.4 cm, but you are still 37.2 cm short, so the box will not sit inside with the tailgate shut. This is a roof-rack or van job, or a flat-pack delivery. Measure your own opening first: parcel shelves and wheel arches steal centimetres the diagram never shows.

Frequently asked questions

Find quick answers about fit for BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm in Renault Captur 2024, including seats up vs seats down, limiting factor, best orientation, and package-by-package margins.

Will BRIMNES Day-bed frame with 2 drawers, white, 80x200 cm fit in Renault Captur 2024?

No. With seats up, it is short by 75.6 cm at Opening width, even with diagonal loading.

What is the tightest part?

The limiting factor is Opening width, with -75.6 cm margin in seats up.

Why does it not fit?

The blocker is Opening width. The worst margin is -75.6 cm in seats up, so clearance is below the required buffer.

Can I load it diagonally?

Yes, diagonal is the best orientation for this check, with -75.6 cm around the limiting point.

Do all packages fit in the car at the same time?

We test each package individually. All packages fitting individually does not guarantee they will fit stacked together. You may need multiple trips.

Does it fit with seats up or seats down?

Seats up: No (-75.6 cm). Seats down: No (-37.2 cm). Default selection follows YES > MAYBE > NO.

Which package is the hardest to load?

Package #1 (206 × 59 × 7 cm) is the tightest, with -75.6 cm at Opening width.

What should I do instead?

Use the Helpful tips & alternatives section to choose a smaller item, different orientation, or split-load plan.

Is the trunk opening the issue?

Yes. The tightest constraint is at the opening (Opening width) with -75.6 cm margin.

How many packages fit and how many do not?

Fit packages: 1. Borderline packages: 1. Not fitting packages: 1.