KALLAX Shelf unit, white, 30 1/8x30 1/8″
+5⅜″ margin
All items that fit an Alfa Romeo Brera 2008
Will fit in an ?
No, it won't fit.
It will not fit in this setup: LISABO Table, ash veneer, 55 1/8x30 3/4″ is too large for an Alfa Romeo Brera 2008 with seats up.
Fit Details
With seats up, This package will not fit in this setup. The blocker is opening height, and you're short by 19″ even with diagonal loading. We're about 95% confident in this estimate.
LISABO Table, ash veneer, 55 1/8x30 3/4″
Box: 64¾″ × 32″ × 2″ · 45 lb
Based on IKEA US (United States).
Package dimensions last checked and updated on Oct 21, 2026
Package
Status
Limiting factor
Best orientation
Package #1
64¾″ × 32″ × 2″
Status:19″ short
Limited by
Limiting factor:Opening height
Best orientation:Diagonal
Vehicle limits
Opening width / height above sill
39″ / 13″
Cargo width / height
33⅛″ / 24″
Cargo length seats up / down
37⅜″ / 59⅞″
Loading sill height
35⅜″
Alfa Romeo Brera 2008
Measurements last checked and updated on Oct 21, 2026
Helpful tips
Use these loading tips to improve your chances of fitting LISABO Table, ash veneer, 55 1/8x30 3/4″ in Alfa Romeo Brera 2008.
Manage opening height
Keep the highest edge low at the trunk opening.
Load diagonally first
Load diagonally first, then straighten once inside.
Try fitting alternatives
Check the Similar items that fit section for safer alternatives.
Alternatives that fit in Alfa Romeo Brera 2008
Ranked by fit margin and package-dimension similarity. This improves as we index more items.
About the Alfa Romeo Brera 2008 boot
The Brera's way in is low. Above the loading sill there is a gap of only 13″, and every box has to pass through it. The tailgate opening is 39″ wide and the floor narrows to 33⅛″. Inside, the floor-to-top height is 24″, but that floor sits 11″ below a high sill at 35⅜″. With the rear seats up, the floor runs 37⅜″, which suits a short flat pack or two. Fold them and the floor reaches 59⅞″, room for longer packs. Find each box's thinnest side before you buy: it has to be 13″ or less to get through.
About the LISABO Table, ash veneer, 55 1/8x30 3/4″ package
One flat box holds the whole LISABO table: 64¾″ × 32″ × 2″, at 45 lb. At only 2″ thick and 32″ wide, it is too thin to grip well and too broad to carry under one arm. Lying flat and straight, it needs 64¾″ of boot floor, and the opening has to clear that 32″ width one way or the other. Carry it between two people, one at each short end, with your hands under the box rather than pinching the thin edges, and keep it level as you lift it and set it down.
Frequently asked questions
Find quick answers about fit for LISABO Table, ash veneer, 55 1/8x30 3/4″ in Alfa Romeo Brera 2008, including seats up vs seats down, limiting factor, best orientation, and package-by-package margins.
Will LISABO Table, ash veneer, 55 1/8x30 3/4″ fit in Alfa Romeo Brera 2008?
No. With seats up, it is short by 19″ at Opening height, even with diagonal loading.
What is the tightest part?
The limiting factor is Opening height, with -19″ margin in seats up.
Why does it not fit?
The blocker is Opening height: with seats up, the box is 19″ bigger than the space there.
Can I load it diagonally?
Yes, diagonal is the best orientation for this check, with -19″ around the limiting point.
Which loading orientation works best?
Diagonal is the best orientation for this result in seats up.
Does it fit with seats up or seats down?
Seats up: No (-19″). Seats down: No (-4⅞″). Default selection follows YES > MAYBE > NO.
What do YES, MAYBE and NO mean here?
YES means there is at least 2⅜″ to spare at the tightest point, in the best way the box can go in. MAYBE means it fits on paper, but with less than 2⅜″ to spare, so trim, the parcel shelf or the loading angle can decide it. NO means the box is bigger than the space at its tightest point, whichever way it goes in. Every margin on this page is that real gap: the car's measurement minus the box's.
What should I do instead?
Use the Helpful tips & alternatives section to choose a smaller item, different orientation, or split-load plan.
Is the trunk opening the issue?
Yes. The tightest constraint is at the opening (Opening height) with -19″ margin.
How tight is this fit?
This result is in the clear no-fit band (-19″ at Opening height).